Welcome to the FOSSCAD Exchange, where you can confabulate with the FOSSCAD community.
+1 vote

Has anyone worked on this or knows someone that has completed a plastic revolving 12 gauge?

I want to print one to fire flares!

Thanks in advance!!

kicked off in Howto by (130 points)

2 Remarks

0 votes
We would probably start out with a 410 and not a 12 gauge because they're less likely to break the gun. Maybe not.
remarked by (200 points)
0 votes
Any tests I've seen with 12 gauge or 410 in a plastic barrel has resulted in catastrophic failure. The shot shreds into the plastic barrel and it frequently explodes.
remarked by (780 points)
Here's a question; what of a standard iron pipe based barrel and plastic receiver?  Any tests of a setup like that, that you're aware of?